Featured Products

Qscan Outdoor 2-D Scanner

Qscan Mini Turnstile and Kiosk Wiegand 12V Imager

Ble1 Bluetooth/Prox Reader

Sproxjx Tri-Technology Reader (barcode / mag / prox)

QscanT Turnstile reader Wiegand 12V Imager with prox and 13.5 Mhz

Smart Mag SA

Stand-Alone Magnetic Stripe reader for Access Control.

 

 
     
The Smart Mag SA is a Stand Alone magnetic stripe reader for use in Access Control. With 64k of memory and an internal relay, the SA series is a low-cost solution for controlling door access. The reader contains 64K of memory (256K optional), which is enough to store 6000 9-digit employee numbers. The reader can be downloaded with valid employee numbers from a PC, or enrollment of cards can be done directly at the reader. "Schedules" are also supported in the reader, so that access can be limited to specific days and times for each employee. All you need to control a door is to install the Smart Mag SA with an electric strike or magnetic lock, and you're up and running. For access control which requires monitored access, such as employee ID verification at guard shacks, the SA reader is also available in a portable version with an internal battery. The SA is available with an Rs232 interface, usb, or tcp/ip. Tcp/ip readers can be POE which allows a door strike to be powered directly through the POE interface.

 

Scanning Speed   3-30 ips (7-76 cm/sec)
Scan Direction   bi-directional
Tracks   Track 2, Tracks 1&2, or Tracks 2&3 hi/lo co
Good Read Beep   programmable
Memory   64K standard, 256K optional
Slot Width   0.050"(1.2mm). Other widths upon special request
Indicators   2 leds (programmable)
Temperature   -40c to +85c
Dimensions   4.6"L x 2.4"W x 1.4" H (11.6cm x 6cm x 3.5cm)
Weight   6 ounces
Material   black polycarbonate (Noryl optional)
Power   5VDC(150ma), 8-15VDC, or 15-30VDC
Standard Wiring   3' (91cm) cable w/flying leads or connectors depending on interface
Relay  

30VDC 500ma Form C
12VDC 700ma direct from POE

Display   optional 8-character alpha for time display
Battery Time (portable)   Approximate 8 hours with alkaline 9-volt battery
POE to strike   12vdc, max 500ma normally open
Available Interfaces:   RS232, RS422, TCP/IP, USB
    RS232, USB (Portable Versions)
     
     

Programmable
Track 2, Tracks 1&2, or Tracks 2&3
-40c to +85c operation
Networkable
Available with POE

5,12, or 24VDC
8-char alpha display
256K memory
0.400" or 0.465" read height
Weatherproofing
#6 or 3mm mounting
Side or Rear wiring
Power over Ethernet
Noryl (chemical resistant)
Portable (9 volt battery)

Mounting Kit
Cable for external 9-volt battery (portable version)
Communications cable (portable version)
AC Adapter (portable version)

IBC software   STA V9.4
3rd party software   Highpower Security Products HMS V1.4 (recommended)